Applications
Home > Applications > Content
Maintenance and maintenance of laser engraving machine
- Feb 02, 2018 -

Maintenance and maintenance of laser engraving machine:

1. Special need to adjust the light intensity should not exceed 20MA, in case the laser tube rapidly aging.

2. The mirror is carefully cleaned on the machine, otherwise it must be reset.

3. It is strictly prohibited to use inferior circulating water. The low quality circulating water can seriously affect the laser power and greatly shorten the service life of the laser tube. The damage of the laser tube caused by the user using inferior water is not covered by the warranty scope. Clean water is recommended.

4. Before each assignment, please pay attention to the focus, and the focus should not seriously affect the engraving effect.

5. The third transmitter and focus mirror should be removed and cleaned. The lens installation should be secure, but not too tight to prevent the lens from breaking.

6. Clean work should be done after each assignment. When doing cleaning, you can gently push the beam and the trolley while the power is off, but it is strictly forbidden to push and pull.

Clean your lenses once a day before turning on the machine (note: not in the second half).

8. Once every other week, the machine peripherals (fan, air pump, etc.) shall be cleaned.

9. The cooling water should not be less than 30 litres and must be immersed in the submersible pump.

10. During the operation, the water temperature must be monitored at any time. Once the water has a warm feeling, the water should be changed immediately (the method of not affecting the operation is to spare some hot water and wash it into cold water).